![]() See your manufacturer's documentation for information about the settings that your monitor supports. ![]() (Your monitors may support multiple refresh rates. If the display doesnt have the capability to run native resolution with the PC input, then itll either do a 1:1 mapping of its highest supported resolution or alternatively, scale one of the supported resolutions to that of the panels - typically 1280x768, which gets widened to 1366. Select a resolution and refresh rate that is supported by all monitors. ![]() Right-click the Windows desktop, and then select Screen resolution To configure the refresh rate of the display: If you experience noticeable cut lines or tearing, and not only when you play a DVD movie, the display may be configured to a refresh rate that one of your monitors does not support. If this is the case, you can resolve the issue by configuring the display to a refresh rate that is supported by all monitors. For information about how to change this setting, go to the following Microsoft website: If your computer does not meet the requirements for Aero, set the display to PC Only or Extended. Otherwise, set the display to PC Only or Extended. For more information about Aero, go to the following Microsoft website: See alsoChange Control Center settings on MacTurn a Focus on or off on. If the computer system meets the hardware and software requirements to run Windows Aero, you may be able to reduce or eliminate the problem by enabling Aero. An orange dot next to the icon indicates the microphone on your Mac is in use. In this case, there may be unavoidable tearing on the second monitor. Even though the two monitors are configured for the same refresh rate (for example, 60 Hz), the second monitor may not be refreshed at the same time. Some video hardware supports multiple monitors but does not synchronize the display redraw timing of the two monitors. When windows synchronizes DVD playback with the monitor refresh rate, it synchronizes with the timing of the primary monitor. The video frame is updated during the vertical blanking interval so that the complete, correct frame will be displayed without any tearing every time that the video card refreshes the monitor. When it is playing video content such as a DVD, the operating system has to synchronize playback with the display redraw rate. There may be a noticeable horizontal line at the point where the two frames meet. This is more noticeable during scenes that contain fast motion. This problem occurs because of a hardware limitation that is known as "tearing." Tearing is a video artifact in which the top portion of the screen shows a different frame of video than the bottom portion. In this scenario, you notice a cut line in the video on one of the monitors. You play a DVD movie in Windows Media Player or a third-party video application. Your display is not set to use Windows Aero. You have the Duplicate (Clone Mode) display configured. Your computer supports two or more monitors. You have a computer that is running Windows Vista or a later Windows operating system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |